Retaining Walls work on an active jobsite

Retaining Walls project guide

Retaining Walls contractors cost and hiring guide

Segmental block, poured concrete, timber and boulder walls built with the base, drainage and reinforcement that keep them standing.

View contractors

Key facts

Retaining Walls numbers you can check

Rules and figures that come up in nearly every retaining walls quote, with the public source for each one.

FactWhat it saysSource
Permit exemption lineModel codes (IBC 105.2) exempt retaining walls up to 4 feet, measured from the bottom of the footing, unless they support a surcharge.International Building Code, Section 105.2 Work Exempt from PermitAs of September 2026
Design requirementsIBC 1807.2 requires retaining walls to resist overturning, sliding, excessive foundation pressure and water uplift.International Building Code, Section 1807.2 Retaining WallsAs of September 2026
Seismic triggerIBC 1807.2 adds seismic lateral earth pressure to the design of walls retaining more than 6 feet of backfill in higher seismic design categories.International Building Code, Section 1807.2 Retaining WallsAs of September 2026

Project guide

Hiring retaining walls contractors

Retaining walls hold back soil where a grade change is too steep to slope, and they fail for one reason far more than any other: water. A wall that lasts has a compacted crushed-stone base, a perforated drain pipe at the heel, clean gravel backfill behind the wall face, and geogrid layers tied into the backfill on anything tall. Segmental concrete block is the most common residential system and can be built by a landscape contractor up to about four feet; above that, or wherever a driveway, slope or structure sits above the wall, an engineer's design is required by most codes and the wall becomes structural work. Poured concrete and reinforced masonry walls are used for tall cuts and tight sites, boulder walls for rural and natural-look projects, and pressure-treated timber for budget walls with a shorter life.

GradeLine lists 1,591 retaining walls contractors.Compare their work and equipment, then confirm availability and service area before requesting a quote.

Listed businesses are based in , Scranton, Hillsboro, Rapid City, Plummer, Crystal Lakes, though most crews travel well beyond their home city.

What retaining walls work costs

Segmental block walls typically cost $25 to $50 per square foot of wall face installed, poured concrete $30 to $60, timber $15 to $30 and boulder walls $20 to $40. A four foot tall, 50 foot long block wall therefore commonly runs $5,000 to $10,000, and engineered walls above that height climb quickly once geogrid, engineering and larger equipment are involved.

Ranges are national and approximate; regional labor rates, material prices and site conditions move them in both directions.

Common projects

  • Segmental block and gravity walls for yards, driveways and terraced slopes
  • Engineered poured concrete, reinforced masonry and sheet pile walls for tall or surcharged cuts
  • Boulder walls, timber walls, terracing and replacement of leaning or failed walls

What affects a quote

  • Wall height and length, and whether a surcharge such as a driveway, pool or slope sits above it
  • Engineering, excavation, base preparation, drainage and geogrid the design requires
  • Block or material type, backfill stone, spoil haul-off and restoring the grade above and below

Retaining Walls FAQ

What does retaining walls work cost?

Segmental block walls typically cost $25 to $50 per square foot of wall face installed, poured concrete $30 to $60, timber $15 to $30 and boulder walls $20 to $40. A four foot tall, 50 foot long block wall therefore commonly runs $5,000 to $10,000, and engineered walls above that height climb quickly once geogrid, engineering and larger equipment are involved.

What should I share when requesting a retaining walls estimate?

Send the height and length of the grade change, a photo of the slope, what sits above and below the wall, where water comes from, and the look you are after.

What can change the cost of retaining walls work?

The main cost items are wall height and length, and whether a surcharge such as a driveway, pool or slope sits above it; engineering, excavation, base preparation, drainage and geogrid the design requires; block or material type, backfill stone, spoil haul-off and restoring the grade above and below. A site visit helps the crew see which ones apply.

Do retaining walls projects need permits?

Most building codes exempt walls under four feet measured from the bottom of the footing with no surcharge, and require a permit and stamped engineering above that. Walls near a property line, a public sidewalk or a stream can trigger additional setback, drainage and environmental review.

Find retaining walls contractors near you

Pick a state to see the retaining walls contractors listed there. Most crews travel well beyond their home city, so confirm the service area before requesting a quote.

Contractor directory

Browse retaining walls contractors

1,591 contractors found

Need a retaining walls contractor in your area?

Tell us about the job and add photos. A local pro calls you back. Free, and no spam.

Request services

Related excavation services

ExcavationGradingSite PrepLand ClearingDemolitionTrenching / Underground
View all services